 Q000189:
How is it possible to connect a RTD sensor with the AI-201 layer ?
And how much mA supplies the AI-201 layer ?
|
|
Q000201:
What kind of pre-filtering is possible? I don't see any. How does the system handle aliasing? 60Hz? Excitation current is limited to 120mA for all channels on the DNA-AI-208 ... this is not enough for me.
I use 350 ohm QBs at 10V ... my current system (MEGADAC) provides 360mA. Suggestions?
|
|
Q000218:
What averaging is built into the 208 layers:
|
|
Q000244:
What are the specs for S/N Ratio, CMRR, Isolation between Channels for AI-201, AI-205, AI-225 Analog Input Layers.
|
|
Q000245:
I have an AC input of +/-100V pk-pk, how can I apply that to AI-205 layer.
|
|
Q000258:
What is the accuracy of DNA-AI-225 layer when used with DNA-STP-AI-U terminal panel?
|
|
Q000259:
What is the accuracy of DNA-AI-207 layer when used with DNA-STP-AI-U terminal panel?
|
|
Q000262:
Does the AI-202/201 provide ±18V power? How much power? What happens if you draw too much power?
|
|
Q000264:
What is the correspondence between resolution in bits and percentile values for 12/16/24 bit data acquisition devices?
|
|
Q000265:
Is there documentation use of the AI-200-series layer with a pressure transducer?
|
|
Q000266:
Is there documentation on use of the AI-225 layer with thermocouples?
|
|
Q000267:
Is there documentation on use of the AI-208 layer with strain gages?
|
|
Q000271:
How long of a switching time of the multiplexer is needed to collect samples from channel to channel on the AI-201-100?
|
|
Q000272:
When will UEI support the RoHS directive?
|
|
Q000275:
I have set the excitation voltage on an AI-208. I measure nothing on my voltmeter. What's wrong?
|
|
|
