 Q000189:
How is it possible to connect a RTD sensor with the AI-201 layer ?
And how much mA supplies the AI-201 layer ?
|
|
Q000194:
What are the environmental / vibration specifications for PowerDNA, UEILogger, UEIPAC and UEIModbus products?
|
|
Q000196:
Does the DB62 connector on the DNA-DIO-403 exist as a flat connector type
|
|
Q000200:
System that consist of DIO-405 layer or DIO-401 and DIO-402 layers, in control loop that uses DMAP mode, data read back from the digital input displayed incorrectly vs. data outputted by the digital output (loopback test). Why?
|
|
Q000201:
What kind of pre-filtering is possible? I don't see any. How does the system handle aliasing? 60Hz? Excitation current is limited to 120mA for all channels on the DNA-AI-208 ... this is not enough for me.
I use 350 ohm QBs at 10V ... my current system (MEGADAC) provides 360mA. Suggestions?
|
|
Q000203:
Using the Fiber Optic cube - how long can we run the fiber cable without a repeater.
|
|
Q000204:
Can I drive 25 ma on the DNA-403 ? The specification write 16 ma but the current limit resistor is 22 ohms ? I have to switch an opto coupler and the current must be 25 ma for working properly . Can I drive this current ?
|
|
Q000206:
DNA-A-225 layer: Does the product support 3 wire RTD ?
|
|
Q000212:
The DNA-STP-37 is identical to the PD-STP-3716. Attached is the schematic.
|
|
Q000214:
Please explain TCP/IP in more detail ?
|
|
Q000218:
What averaging is built into the 208 layers:
|
|
Q000221:
What fiberoptic transmitter do you use on the Fiber Optic models of the PowerDNA cubes
|
|
Q000225:
What is the AWG size range for field terminations that the DNA-STP-AI-208 module can be connected to?
|
|
Q000226:
Are there any restrictions on the copper ethernet wiring for
the DNA-CM-5 unit in addition to their requirement for RJ-45 connectors?
|
|
Q000244:
What are the specs for S/N Ratio, CMRR, Isolation between Channels for AI-201, AI-205, AI-225 Analog Input Layers.
|
|
|
