 Q000189:
How is it possible to connect a RTD sensor with the AI-201 layer ?
And how much mA supplies the AI-201 layer ?
|
|
Q000201:
What kind of pre-filtering is possible? I don't see any. How does the system handle aliasing? 60Hz? Excitation current is limited to 120mA for all channels on the DNA-AI-208 ... this is not enough for me.
I use 350 ohm QBs at 10V ... my current system (MEGADAC) provides 360mA. Suggestions?
|
|
Q000245:
I have an AC input of +/-100V pk-pk, how can I apply that to AI-205 layer.
|
|
Q000258:
What is the accuracy of DNA-AI-225 layer when used with DNA-STP-AI-U terminal panel?
|
|
Q000259:
What is the accuracy of DNA-AI-207 layer when used with DNA-STP-AI-U terminal panel?
|
|
Q000262:
Does the AI-202/201 provide ±18V power? How much power? What happens if you draw too much power?
|
|
Q000264:
What is the correspondence between resolution in bits and percentile values for 12/16/24 bit data acquisition devices?
|
|
Q000265:
Is there documentation use of the AI-200-series layer with a pressure transducer?
|
|
Q000266:
Is there documentation on use of the AI-225 layer with thermocouples?
|
|
Q000267:
Is there documentation on use of the AI-208 layer with strain gages?
|
|
Q000271:
How long of a switching time of the multiplexer is needed to collect samples from channel to channel on the AI-201-100?
|
|
Q000272:
When will UEI support the RoHS directive?
|
|
Q000275:
I have set the excitation voltage on an AI-208. I measure nothing on my voltmeter. What's wrong?
|
|
Q000281:
Does the 120mA limit on the DNA-AI-208 layer apply to the "total load",
which is really the combined load of whatever two channels are on
simultaneously?. Also, does this also mean that the layer must never
drive a 120ohm bridge at 10 volts (which would consume 83mA)?
|
|
Q000286:
Why does my thermocouple reading not go any higher than 739(or 422 or 985 etc.) degrees?
|
|
|
