Okay

Get in Touch

General
(508) 921-4600
Email Sales
Email Support

UEI Europe Office
+49 40 63698136
Email EU Sales

Visit this page for local offices and distributors.

FLATRACK I/O chassis mounting extension bracket

DNF-EXTBRACKET4

Features

FLATRACK I/O chassis mounting extension bracket

  • Allows FLATRACK I/O chassis to be mounted further from the 19" rack front panel
  • Provides 3.625 inches of clearance between 19” rack front panel and chassis
  • Easy to install, uses existing mounting holes and hardware
  • Allows bulkhead (rear) mounting configurations to be mounted further from bulkhead if required
FLATRACK I/O chassis mounting extension bracket
Quantity: $165
Add to Cart

Typically in stock for shipment in 3-4 weeks. Subject to global supply chain challenges.

DNF-EXTBRACKET4

The DNF-EXT-BRACKET-4 is designed to allow DNF Ethernet, EtherCAT, UEIPAC, UEISIM, Modbus and OPC-UA series FLATRACK I/O chassis to be installed“deeper”in 19" racks than the standard brackets provided with the units. The extended brackets provide a full 3.625 inch clearance between the front panel of the 19" rack and the front of the FLATRACK I/O chassis.

In applications taking advantage of the FLATRACK'S rear, bulkhead mounting configuration, the extension bracket can be used to extend the clearance between the rear panel of the FLATRACK and the bulkhead it is mounted on to approximately 5.25 inches.

The bracket is designed to use existing mounting holes and hardware, so it is very easy to install on the FLATRACK as well as in your rack.

Downloads

Compatibility